[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Tank Lids An answer and a couple of questions for oldtimers.
George,
Great idea! Where did you get the white vinyl strip?
erny
----- Original Message -----
From: "George & Melanie" <caraway at erienet_net>
To: <killietalk at aka_org>
Sent: Saturday, September 01, 2001 2:48 PM
Subject: Re: Tank Lids An answer and a couple of questions for oldtimers.
> Adding a different idea to the mix, I made tops for all of my 2 1/2 gal
tanks from the white plastic macrame grids that you get at the craft store
for about 25 cents each. I cut the grid so it is slightly larger than the
tank top. Then I purchase that white vinyl strip made for using along the
edge of glass or plexiglass. It has a small channel in it and comes in 8
foot lengths. I cut this in lengths to suit the sides of the plastic grids.
Then hot glue them
> around the edges of the plastic grid. It is easy to cut a hole out in the
grid to suit the location of your air line if necessary. It gives you a nice
light but rigid cover that is easily lifted to feed, etc.
> George
>
> Barry Cooper wrote:
>
> > When I was using clear plastic sheets for tank lids I used to glue a
narrow strip (about 1/2") across the lid near one edge, cut a little shorter
that the span of the tank, so it did not prevent the lid from seating
properly. I used the special solvent/glue sold by the plastics folks for
that purpose. You need to be careful to use it outdoors or in a very well
ventilated area. Anyway, that reduced the tendency to bow. However, in the
end, I went back to glass.
> >
> > Barry
> >
> > At 11:41 AM 9/1/01 -0500, you wrote:
> > >Regarding ceiling tile lids.
> > >
> > >This may be way out in "left field," but I have to ask anyway. Would
it be possible to spray the underside of the lids with a polyurathane to
seal it off from moisture? That would prevent the material from absorbing
the moisture that causes warping.
> > >
> > >Also, could one attach a non-plastic brace across the top, such as a
short piece of aluminum "L" stock> That would hold the weight of the
plastic and prvent it from bowing.
> > >
> > >Just a few ideas.
> > >---------------
> > >See http://www.aka.org/AKA/subkillietalk.html to unsubscribe
> >
> > ___________________________________________________
> > Barry J. Cooper, Prof., Dept. Biomedical Sciences, Cornell University
> > Current address: 27505 Riggs Hill Rd.
> > Sweet Home, OR 97386 (bjc3 at cornell_edu)
> >
> > ---------------
> > See http://www.aka.org/AKA/subkillietalk.html to unsubscribe
>
> ---------------
> See http://www.aka.org/AKA/subkillietalk.html to unsubscribe
>
---------------
See http://www.aka.org/AKA/subkillietalk.html to unsubscribe
Follow-Ups:
References: