[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Correct Temp from Faucet to Tank with Python
For those folks using a Python Water Changer, how do you
get the temperature you want going into the tank. My
faucet handles must slip somewhat because a few times I
have been surprised that the water coming out was either
too cold or too warm. No problem for a small water change,
but with the tannins from my driftwood I do large water
changes every so often. Is there a way to get a
thermometer inline?
I can test the water going into the tank but then I'm the
one holding the python and I can't go adjust the faucet
again.
My solution has been to use the python to send the water
into a bucket by the tank. Then I use a submersible heater
to heat the water and a maxi jet to send the water from
the bucket back to the tank. It is getting rather
complicated.
I would appreciate any advice.
Michael
___________________________________________________
GO.com Mail
Get Your Free, Private E-mail at http://mail.go.com