[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [APD] Adjusting Water Height
If you use a stand pipe, you can adjust the water level up or down within the range of the upper slots. If light is escaping between the rim and the water, sounds like the water should be raised a little.
sh
* * * * * * * * *
The deadline is Oct 12 for getting the special Convention room rate!
Read about the Aquatic Gardeners Association Convention at
http://www.aquatic-gardeners.org/convention.html
----- Original Message ----
From: Jerry Baker <jerry at bakerweb_biz>
To: APD <aquatic-plants at actwin_com>
Sent: Saturday, September 23, 2006 12:32:23 AM
Subject: [APD] Adjusting Water Height
I have a small niggle with my current set up. The water level is just a
fraction of an inch too low. It allows some light from the metal halides
to escape from between the tank's molding and the water surface. This
makes a very bright line of light across the coffee table and TV screen.
Since I have a built-in overflow I cannot adjust the height of the
teeth. Are the any tricks to raising the water level some without very
involved modifications?
Thanks.
--
Jerry Baker
_______________________________________________
Aquatic-Plants mailing list
Aquatic-Plants at actwin_com
http://www.actwin.com/mailman/listinfo/aquatic-plants
_______________________________________________
Aquatic-Plants mailing list
Aquatic-Plants at actwin_com
http://www.actwin.com/mailman/listinfo/aquatic-plants