[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: CO2 regulator and 5# CO2 tank info (fwd)

> I saw some info on this supplier on the krib in a message from 1996 but
> the contact info was out of date.  On the krib it mentioned using a 0-10#
> regulator to get the pressure low enough to not need a needle valve.

I think you end up needing a needle valve regardless of the regulator
output pressure.  Even if the output is set at 1 PSI, it's going to
be putting out a constant rapid stream of bubbles, unless you are putting
some resistance on the co2 line.